Logistic growth rate functions

doi:10.1016/0022-5193(68)90058-1

Journal of Theoretical Biology

Volume 21, Issue 1, October 1968, Pages 42-44

https://doi.org/10.1016/0022-5193(68)90058-1 Get rights and content

Abstract

Assuming an S-shaped population or organism size versus time curve and a growth rate law of the form $d P d t = constant XP^{a} (P_{∞} −P)^{b}$ where P is the population or size at any time, t, and P_∞ is the limiting population at infinite time, several methods are available for evaluating the exponential pair (a, b). At the inflexion a simple relation exists between $P P_{∞}$ and the pair. In addition the rate equation can be converted to an integral function from which, in turn, the best pair to describe the growth rate can be obtained graphically. The integral function for $(a, b) = (1, 1), (2, 1), (2, 2), (12 1), (32, 1) and (23, 1)$ are given. Identity relations permit easy calculation of the functions for the conjugate pairs (b, a).

References (13)

R. Pearl et al.
Metron Rovigo
(1923)
L.E. Bayliss
A.A. Blumberg et al.
J. phys. Chem., Ithaca
(1960)
S. Brody
Bioenergetics and Growth
(1945)
A.J. Fabens
Growth
(1965)
B. Gompertz
Phil. Trans. R. Soc.
(1825)

There are more references available in the full text version of this article.

Cited by (80)

A simplified approach to the prediction of mixed and boundary friction
2022, Tribology International
Citation Excerpt :
This would suggest that at high λ values the real contact area should be roughly proportional to load, as expected. The above equation differs slightly from that reported by Blumberg [36] since a negative sign has been used on the right-hand side of the equation. This is because X decays (rather than increases) with λ.
Improving machine energy efficiency has led to the use of lower viscosity lubricants, and a greater chance of mixed/boundary contact occurring. A new equation, derived from experimental data, is proposed that enables simple calculation of the proportion of mixed/boundary friction in a contact, as a function of the λ ratio. It is also shown that some commonly used rough surface contact models (such as the Greenwood Tripp model) significantly underestimate mixed/boundary friction in the range 1 < λ < 3. The new model has the form of an S-curve, which suggests a new approach to rough surface contact modelling is to treat it as a growth/decay process, and the consequences of this approach are discussed
A new growth curve model portraying the stress response regulation of fish: Illustration through particle motion and real data
2022, Ecological Modelling
Citation Excerpt :
Moreover, the interplay of two different stress response pathways may lead the fish body’s growth trajectory to various sigmoidal forms. Blumberg (1968) and Tsoularis and Wallace (2002) proposed generalized versions of logistic law to portray both symmetric and asymmetric growth profiles by incorporating parameters for up and down-regulations of metabolisms in physiological growth. Since conceptually, these two laws also lack separate parametric representations for the aforementioned metabolic depression, these laws also need further extensions to portray fish growth under chronic stress other than resource limitation.
A fish has to grow in an aquatic environment with both positive and negative regulatory mechanisms under stress. Metabolic upregulation acts as a positive regulatory mechanism while metabolic downregulation acts as the negative regulation. These two mechanisms work as a response to the stress on the fish body. The Tsoularis–Wallace (TW) model can portray the two aforementioned metabolic regulations but is not applicable for fish growth under chronic stress. If the stress is chronic, then the fish body develops a metabolic depression in addition to these two aforementioned metabolic regulations. We capture stress effects through regulators similar to the regulators of population ecology in a proposed generalized model (PGM). At the same time, the chronic stress induced metabolic depression is considered in the PGM through a harvesting-like term in this study. Our PGM can capture all the conceptual phenomenon to describe the real data sets well. Like the TW model, our PGM has no analytical solution. Therefore, we propose a linearized model (PLM) from the PGM to overcome this problem. We used the mean fish body length data sets for four locations as used in Chakraborty et al. (2017). The relative growth rate (RGR) profiles of the PLM better fitted to the observed RGR values of the real data sets than the previously used models in three of the four cases. Comparing the fish body growth with the motion of a particle in Newtonian mechanics, we formulate the three broad phases (lag, log, and stationary) ending time points and the corresponding fish lengths. We also obtain the point of inflection regarding time and the corresponding length. We calculate all of these results for the real data sets. The metabolic downregulation and capacity limitation of our model cause a decreasing trend in maximum body length of the fish upon simulation. Metabolic depression rate parameter of our model is also a key control of the maximum body length of fish as per the simulation.
Modeling the influence of microbial growth on the hydraulic properties of porous media
2022, Computers and Geotechnics
Pore blocking dominates hydraulic conductivity in the processes of solute transport. Recent biological experiments have shown that the growth of microorganisms in these pores influences their hydraulic characteristics. This study proposes a microbial clogging kinetic model to examine the effects of bio-clogging based on Logistic microbial growth model. The results show that microbial clogging mainly depends on dead microbial cells rather than living microbial cells, and the contribution of dead microorganisms to microbial fouling is about 99%. The final clogging results depend on depends on the average microbial volume V_m, the maximum environmental carrying capacity K, the volume reduction coefficient of dead microorganism k_d, the microbial growth rate r and the cell decomposition time T_d. Compared with the experiments results, the R² of the proposed model is exceeds 90%, which means that the model can well reflect the process of microbial clogging.
Structures and evolution of bifurcation diagrams for a one-dimensional diffusive generalized logistic problem with constant yield harvesting. II. Convex-concave and convex-concave-convex nonlinearities
2022, Journal of Differential Equations
We study the diffusive generalized logistic problem with constant yield harvesting:where $λ, μ > 0$ . We assume that g satisfies $g (0) = g (1) = 0$ , $g (u) > 0$ on $(0, 1)$ , and g is either convex-concave or convex-concave-convex on $(0, 1)$ and satisfies certain conditions. We prove that, for any fixed $μ > 0$ , on the $(λ, {‖ u ‖}_{\infty})$ -plane, the bifurcation diagram always consists of a continuous, ⊂-shaped curve, and we study the structures and evolution of bifurcation diagrams for varying $μ > 0$ . We also prove that, for any fixed $λ > λ_{0}^{⁎}$ for some $λ_{0}^{⁎} > 0$ , on the $(μ, {‖ u ‖}_{\infty})$ -plane, the bifurcation diagram consists of a reversed ⊂-shaped curve with possibly the disjoint union of a strictly increasing curve, and we study the structures and evolution of bifurcation diagrams for varying $λ > λ_{0}^{⁎}$ . Our results complement those of Hung, Suen, and Wang (2020) [10] in which problem g is either concave or concave-convex on $(0, 1)$ .
COVID-19 pandemic models revisited with a new proposal: Plenty of epidemiological models outcast the simple population dynamics solution
2021, Chaos, Solitons and Fractals
We have put an effort to estimate the number of publications related to the modelling aspect of the corona pandemic through the web search with the corona associated keywords. The survey reveals that plenty of epidemiological models outcast the simple population dynamics solution. Most of the future predictions based on these epidemiological models are highly unreliable because of the complexity of the dynamical equations and the poor knowledge of realistic values of the model parameters. The incidence time series of top ten corona infected countries are erratic and sparse. But in comparison, the incidence and disease fitness relationships are uniform and concave upward in nature. These simple profiles with the acceleration curves have fundamental implications in understanding the instinctive dynamics of the corona pandemic. We propose a simple population dynamics solution based on the incidence-fitness relationship in predicting that a plateau or steady state of SARS-CoV-2 will be reached using the basic concept of geometry.
Dynamical analysis of a spatial memory prey–predator system with gestation delay and strong Allee effect
2024, Zeitschrift fur Angewandte Mathematik und Physik

View all citing articles on Scopus

View full text

Logistic growth rate functions

Abstract

Metron Rovigo

J. phys. Chem., Ithaca

Bioenergetics and Growth

Growth

Phil. Trans. R. Soc.